I tried searching this but couldn't find anything. So when I turn my Ac on there is a high pitch squeal that happens for a little bit then usually stops. I heard this could be my clutch going out or some kind barring. If any one else had seen this what was your problem

__________________
[SIGPIC][/SIGPIC]Installed,cb radio,old man emu, al upper control arms, solidaxel diff cover,aspen creek grille insert, 1.5 spacers,265,70,17 at3, 6000k hid lows, k&n intake, flowmaster 40 exhaust,high flow cats, powerwire, superchips flashpaq, Flyin Ryan ported TB 4xguard brush guard.

probably your belt slipping. does it also do it when you stomp on the gas, with the a/c on?

__________________

Build thread:http://www.jeepgarage.org/f14/whoas-...ead-33075.html '05 wk 5.7 hemi limited: FlyinRyan trans tune+WK bilsteins+WK eibachs+self built CAI+cherry bomb vortex+dual rear exit exhaust+blacked out pillars+20% front tint+tinted tails+color matched trim+DS predator+mopar front lip +BT catch can+ 285/30/22 toyo proxes + 22" status dynasty's+ 20% UD pulley +Stainless upper radiator hose+ 10" sub + I simple ipod intergration + addco rear sway...

yeah it gets louder when i give it gas with ac but only when ac is on it makes the noise

__________________
[SIGPIC][/SIGPIC]Installed,cb radio,old man emu, al upper control arms, solidaxel diff cover,aspen creek grille insert, 1.5 spacers,265,70,17 at3, 6000k hid lows, k&n intake, flowmaster 40 exhaust,high flow cats, powerwire, superchips flashpaq, Flyin Ryan ported TB 4xguard brush guard.

I would change the belt- quick, easy & cheap!

__________________

Build thread:http://www.jeepgarage.org/f14/whoas-...ead-33075.html '05 wk 5.7 hemi limited: FlyinRyan trans tune+WK bilsteins+WK eibachs+self built CAI+cherry bomb vortex+dual rear exit exhaust+blacked out pillars+20% front tint+tinted tails+color matched trim+DS predator+mopar front lip +BT catch can+ 285/30/22 toyo proxes + 22" status dynasty's+ 20% UD pulley +Stainless upper radiator hose+ 10" sub + I simple ipod intergration + addco rear sway...

ok thanx is there and forum that you have seen that walks you through that

__________________
[SIGPIC][/SIGPIC]Installed,cb radio,old man emu, al upper control arms, solidaxel diff cover,aspen creek grille insert, 1.5 spacers,265,70,17 at3, 6000k hid lows, k&n intake, flowmaster 40 exhaust,high flow cats, powerwire, superchips flashpaq, Flyin Ryan ported TB 4xguard brush guard.

I didnt see one on here. Any haynes or chiltons manuel will, but its pretty easy. wait till its cooled off, there should be a tensioner pulley that has a spot to put a socket or breaker bar in so you can release the tension, then slip the belt off. there is a picture of the belt routing under the hood so you get it on properly, then pull the tensioner again to get the belt back around it. I dont know if autozone will change belts for you or not, but you could ask.

__________________

Build thread:http://www.jeepgarage.org/f14/whoas-...ead-33075.html '05 wk 5.7 hemi limited: FlyinRyan trans tune+WK bilsteins+WK eibachs+self built CAI+cherry bomb vortex+dual rear exit exhaust+blacked out pillars+20% front tint+tinted tails+color matched trim+DS predator+mopar front lip +BT catch can+ 285/30/22 toyo proxes + 22" status dynasty's+ 20% UD pulley +Stainless upper radiator hose+ 10" sub + I simple ipod intergration + addco rear sway...